Spod TJ 2003-2006 Instructions Center Bracket User Manual download pdf

sPOD Installation Instructions

2003 – 2006 Wrangler

www.4x4s-POD.com

PN 500-300 Clip

PN 500-100

Windshield Header

Tools required

• Phillips head screw driver.

• Flat head screw driver.

• 15mm socket with a 6” extension

• 1 inch drill / hole saw (for harness exit)

1. Assembly Instructions

• Remove the battery from the Jeep.

• Remove existing plastic windshield header cover by swinging the visors out of the way and pull the plastic

windshield header straight out until all 5 clips pop out of windshield frame.

• Remove the passenger sun visor and then loosen the right hand (passenger side) pillar piece using a

phillips head screwdriver to loosen the 3 screws. “Note” that you do not need to remove the plastic, just

loosen it!

• Install PN500-300 Clips 4pl. where shown in the original horizontal slots on the windshield frame by

inserting one end of the clip’s flange and then angle upward. Use a flat head screwdriver and push clip

flange in until it snaps in place.

• Install switch panel into header PN500-100 feed your wiring through the front switch panel opening and

feed the harness out through the end as required.

• Attach switch bezel to header using the 10/32 Phillips head screws & lock washers provided, slide switch

panel through the opening, align holes and tighten all 4.

1 2 3

sPOD Installation Instructions 2003 – 2006 Wrangler www.4x4s-POD.com 1 PN 500-300 Clip PN 500-100 Windshield Header Tools required • Phillips head

Page 2

sPOD Installation Instructions 2003 – 2006 Wrangler www.4x4s-POD.com 2 Send wire harness and terminals down through here. • Now you are ready to att

Page 3

sPOD Installation Instructions 2003 – 2006 Wrangler www.4x4s-POD.com 3 Ground connection (BLACK) Positive connection (RED) Auto Reset Circuit Breaker

Spod TJ 2003-2006 Instructions Center Bracket User Manual